Sorry about the image quality, but it's a webcam.  I circled the problem tabs.  It looks like the same picture, but it's not.  They just happen to be in the same place when the phone is rotated.  One is in the top right corner of the phone, the other in the bottom left.

The skin is only overlapping by about a millimeter... which is small enough to be difficult to trim, and large enough to be a royal pain the ass.  I might just slice off a good 3 mm because it's not in a really bad area to lose skin, and it'll be easier to remove.  I dunno...  I'll do it later tonight and let you know how I made out.

I'm just scared to death, because I don't want to slice the phone, so I'll probably making the lightest possible scores with a new razor and gently pulling up & away with tweezers until it breaks off.

No, but those *ears* are what I'm talking about... see my pictures above.  They haven't caught on anything yet, but I'm sure they will, which is why I'm going to attempt a trim job later tonight, to prevent that. 

I don't see the skin "falling off" though.  It's on there pretty good.  The problem is this area.  I wish they just made one to cover the screen and stop at the curve.  If this becomes a problem, I may trim down my remaining skin and try it that way.

Other than this, it's a very nice skin... and it doesn't have the "orange peel" effect that invisible skin has.  I don't blame Phantom for this... it's the design of the Pre...  it's a very difficult shape to build a skin for. 

give me 10 minutes and I'll post the picture

OK I stole Tib's picture from page 1 and made my own highlights.

Please direct your attention to the ORANGE box.  The "ears" are marked in blue, and the part they overlap are purple.

If you're going to trim, trim the blue.

I didn't have a problem with those...


Just saying.

how high did you drop it from?

and can you drop it from the same height without the ph skinz and do a comparison? jk...

But my first question was serious?

So just got my phantom skins tonight and just put on the top piece... No overlapping. But  right now on the screen it looks like the underside of the skin has a haze in spots or like there is finger prints on it but they're not fingerprints.

As the instructions said I wet the thing down before and all my fingers were wet when I peeled it off and during the install of the skin so I hope it's just water (doesn't look like it) and will come out by the morning. Will have to wait and see I guess